User Manual
TABLE OF CONTENTS 1. Before you Begin ................................................................................. 3 What is Included................................................................................................ 3 Unpacking Instructions ...................................................................................... 3 Claims ........................................................................................................................ 3 Text Conventions ...............
1. BEFORE YOU BEGIN What is Included 1 x LFS-5 1 x Power Cord 4 x Metal Gobos 1 x Warranty Card 1 x Quick Reference Guide Unpacking Instructions Immediately upon receipt, carefully unpack this product and check the container to make sure you have received all the parts indicated above in good condition.
Product at a Glance Use on Dimmer Outdoor Use Sound Activated DMX Master/Slave Safety Notes Auto Programs Auto-ranging Power Supply Replaceable Fuse User Serviceable Duty Cycle Please read the following Safety Notes carefully before working with this product. They include important safety information about its installation, usage, and maintenance.
2. INTRODUCTION Product Overview Power In Fuse Holder Bracket Adjustment Knob Power Out Mounting Bracket Framing Shutter (x4) Gobo holder knob Focus and zoom control Gel holder LFS-5 User Manual (Rev.
Product Dimensions Page 6 of 14 LFS-5 User Manual (Rev.
3. SETUP AC Power This product has an auto-ranging power supply and it can work with an input voltage range of 100~240 VAC, 50/60 Hz. To determine the power requirements for this product (circuit breaker, power outlet, and wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart. The listed current rating indicates the product’s average current draw under normal conditions.
Power Linking Power Linking Diagram This product provides power linking via the Edison outlet located in the back of the unit. Please see the diagram below for further explanation. 1st Product 2nd Product 3rd Product Other products You can power link up to 23 LFS-5 units on 120 VAC or up to 45 LFS-5 units on 230 VAC.
Mounting Before mounting this product, read and follow the safety recommendations indicated in the Safety Notes section (page 2 of this manual). Orientation The LFS-5 may be mounted in any position; however, make sure adequate ventilation is provided around the product. Rigging Before deciding on a location for this product, always make sure that it will be easy to access the unit for maintenance purposes. Make sure that the structure onto which you are mounting this product can support its weight.
4. OPERATION Power To turn on your LFS-5, simply plug in the including power cord to the back of the product and plug the opposite end to the wall outlet. To turn it off, unplug the power from the wall outlet. Framing Shutters To control the shape of the beam from the LFS-5, use the framing shutters on all sides of the product. The left framing shutter controls the right side of the light, the top framing shutter controls the bottom of the light and vice versa.
5. TECHNICAL INFORMATION Product Maintenance Dust build up reduces light output performance and can cause overheating. This can lead to reduction of the light source’s life. To maintain optimum performance and minimize wear, you should clean your lighting products at least twice a month. However, be aware that usage and environmental conditions could be contributing factors to increase the cleaning frequency. To clean this product, follow the instructions below: Unplug the product from power.
General Troubleshooting Symptom Circuit breaker or fuse keeps blowing Product does not power up Possible Cause Possible Action Excessive load on the circuit Make sure that the total load does not exceed 80% of the breaker or fuse nominal current Short circuit along the power lines Check the power lines and power cords No energy on power outlet Check power outlet Change to another outlet Loose or damaged power cord Check the power cord Blown fuse Replace blown fu
Contact Procedure CHAUVET® Contact Information In case you need to return a product or request support, follow the procedure below: If you live in the US, contact CHAUVET® World Headquarters (see below). If you live in the UK or Ireland, contact CHAUVET® Europe Ltd.(see below). If you live in any other country, DO NOT contact CHAUVET®. Instead, contact your distributor of record. Refer to our Web site for contact details of distributors outside the US, United Kingdom, or Ireland.
6. TECHNICAL SPECIFICATIONS Dimensions and Weight Length Width Height Weight 12.7in (325mm) 8in (205mm) 9in (229mm) 3.2lbs (1.5kg) Note: Dimensions in inches rounded to the nearest decimal digit. Power Light Source Photo Optic Thermal Ordering Page 14 of 14 Power Supply Type Range Voltage Selection Switching (internal) 100~240V, 50/60Hz Auto-ranging Parameter 120V, 60Hz 230V, 50Hz Consumption 52W 56W Operating 0.4A 0.
