Manualshelf

User manual

ManualsBrandsChauvet ManualsDJ EquipmentLFS-75DMX
891011121314151617
LFS-75DMX User Manual Page 13 of 17
Configuration
(Standalone)
Set the product in the standalone Manual mode to control without a DMX controller.
• Connect the product to a suitable power outlet.
Never connect a product that is operating in a standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
Manual Mode
To enable the Manual mode, do the following:
1. Press <MODE/ESC> repeatedly until MAN shows on the display.
2. Press <ENTER> and CoLr, CoSP, dimm, or SHut shows on the display.
3. Use <UP> or <DOWN> to select the desired option as follows.
To select a color from the color wheel options:
1. Select CoLr and press <ENTER>.
2. Use <UP> or <DOWN> to select Co00—Co17.
3. Press <ENTER>.
When CoLr is set to Co16 or Co17, select the color wheel scroll speed as follows:
1. Select CoSP and press <ENTER>.
2. Use <UP> or <DOWN> to select CP00—CP63.
3. Press <ENTER>.
For dimmer control:
1. Select dimm and press <ENTER>.
2. Use <UP> or <DOWN> to select L000—L255 (0—100%).
3. Press <ENTER>.
To select the shutter speed:
1. Select SHUt and press <ENTER>.
2. Use <UP> or <DOWN> to select S000—S100.
3. Press <ENTER>.
Display
Orientation
You are able to flip the LED display for easy readability in any mounting situation.
To select your display angle:
1. Press <MODE/ESC> repeatedly until diS (normal) or rdiS (inverted) shows on the
display.
2. Use <UP> or <DOWN> to select the desired orientation.
3. Press <ENTER>.
Temperature
Display
To view the LED’s temperature, press <MODE/ESC> repeatedly until tCXX shows on
the display. The temperature will be shown in degrees Celsius.
Reset Software
To reset the software in the LFS-75DMX, do the following:
1. Press <MODE/ESC> repeatedly until rESt shows on the display.
2. Press <ENTER>.
Load Factory
Defaults
To load the factory default settings in the LFS-75DMX, follow the instructions below:
1. Press <MODE/ESC> and until LoAd shows on the display.
2. Press <ENTER>.