User manual

Page 12 of 16 COREbar™ 4 User Manual
Configuration
(Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
• Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode (Static,
Automatic, or Sound-Active)
to a DMX string connected to a DMX controller.
Products in standalone mode may transmit DMX signals that could interfere with
the DMX signals from the controller.
Sound-Active
Mode
To enable the Sound-Active mode, do the following:
1. Press <MENU> repeatedly until Snd shows on the display.
2. Press <ENTER>.
3. Turn the music on and adjust the sound sensitivity knob until the product starts
responding to the beat of the music.
4. Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
Automatic Mode
To enable the Automatic mode, follow the instructions below:
1. Press <MENU> repeatedly until AUTO shows on the display.
2. Press <ENTER>.
Auto Program
Speed
To set the auto program speed, do the following:
1. Press <MENU> repeatedly until S-- shows on the display.
2. Press <ENTER> and S 1—S100 (slow to fast) shows on the display.
3. Use <UP> or <DOWN> to select the desired auto program speed.
4. Press <ENTER>.
Footswitch
Operation
The included footswitch provides quick access to preset colors, color-change programs, and
sound-activation through the COREbar™ 4 microphone.
To use the footswitch:
1. Power the product on.
2. Connect the footswitch to the COREbar™ 4 with the 4-pin connection cable with plug.
3. Press pedal #1 (Presets) to activate control. When working, all the LEDs will light white,
which is the first function of pedal #1.
4. Use the chart below to activate the desired function.
To disconnect the footswitch:
1. Unplug the footswitch from the COREbar™ 4.
2. Unplug the power cable from the COREbar™ 4.
3. Power the COREbar™ 4 again to operate without the footswitch.
Pedal
Sub-option
Function
1 - Presets
1 x press
White
2 x press
Red
3 x press
Green
4 x press
Blue
5 x press
Yellow
6 x press
Magenta
7 x press
Cyan
8 x press
Color change every second in a continuous loop
9 x press
Color change every 3 seconds in a continuous loop
2 - Sound
N/A
Sound-activated
3 - Blackout
N/A
Immediately turns off all the LEDs
The COREbar™ 4 footswitch will work properly in any mode. No settings are
needed to be modified before using the footswitch.