User manual

COREbar™ 4 User Manual Page 9 of 16
Mounting
Before mounting the product
, read and follow the safety recommendations indicated in
the Safety Notes.
Orientation
The COREbar™ 4
may be mounted in any position; however, make sure adequate
ventilation is provided around the product.
Rigging
• Before deciding on a location, always make sure there is easy access to the product
for maintenance and programming.
• Make sure that the structure or surface onto which you are mounting the product
can support the product’s weight (see the Technical Specifications
).
• When mounting the product overhead, always use a safety cable.
Mount the
product securely to a rigging point, such as an elevated platform or a truss.
• When rigging the product onto a truss, you should use a mounting clamp of
appropriate weight capacity. The bracket has a 13-mm holes, which are
appropriate
for this purpose.
• When power linking multiple products, you must always consider the length of the
power linking cable and mount the products close enough for the cable to reach.
• The bracket adjustment knobs allow for directional adjustment when aiming the
product to the desired angle. Only loosen or tighten the bracket knobs manually.
Using tools could damage the knobs.
• The L-brackets also serve as floor supports. When mounting the product
on the
floor, make sure that the product and cables are away from people and vehicles.
Mounting Diagram
Pod tilt
adjustment
knobs
Tripod Insertion
Mounting Clamps
Safety Cable
Pod Pan Adjustment Knobs