User manual

Mini Kinta™ User Manual (Rev. 2) Page 11 of 15
DMX Channel Modes, Assignments, and Values
3-CH
Channel Function Value Setting
1 Control/Operating Mode
000  005
006  020
021  035
036  050
051  065
066  080
081  095
096  110
111  125
126  140
141  155
156  170
171  185
186  200
201  215
216  230
231  255
No function
Red
Green
Blue
White
Red/Green
Red/Blue
Red/White
Green/Blue
Green/White
Blue/White
Red/Green/Blue
Red/Green/W hite
Green/Blue/White
Red/Green/Blue/White
Automatic (4-color chase)
Automatic (7-color chase)
2 Strobe
000  005
006

255
No strobe
Strobe (slow~fast)
3 Motor Rotation
000
001  127
128  255
No function
Motor indexing
Motor speed (bi-directional)
Configuration
(Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
Never connect a product that is operating in any standalone mode (either Static,
Automatic, or Sound) to a DMX string connected to a DMX controller. Products in
standalone mode may transmit DMX signals that could interfere with the DMX
signals from the controller.
Automatic/Sound-
Active Mode
To enable the automatic show with sound-active mode, follow the instructions below:
1. Press <MENU> repeatedly until Auto shows on the display.
2. Press <ENTER> and Aut shows on the display.
3. Turn the music on and adjust the microphone sensitivity knob until the product
responds to the beat of the music.
The product will only respond to low frequencies of music (bass and drums).
Color Control and
Strobe
To control the color and strobe, follow the instructions below:
1. Press <MENU> repeatedly until CoLo shows on the display.
2. Press <ENTER> repeatedly until rXXX (red), GXXX (green), bXXX (blue), or UXXX
(white) shows on the display.
3. Use <UP> or <DOWN> to select the desired color value (000~255).
NOTE: Select 000 to turn the color off.
4. Press <ENTER> to select the color value and go to the next color.
5. Repeat steps 3 and 4 for each subsequent color and its value.
6. Press <ENTER> repeatedly to select the strobe speed Str1~Str3 (slow~fast).