User's Manual

5200 N.W. 108th Ave., Sunrise, FL 33351 U.S.A. [phone] – [phone] [e-mail]
Contact Us
General Information Technical Support
Chauvet World Headquarters
Address: 5200 NW 108th Avenue
Sunrise, FL 33351
Voice: [phone]
Toll free: [phone]
Voice: [phone]
Email:
[e-mail]
Website:
www.chauvetprofessional.com
Chauvet Europe Ltd
Address: Unit 1C
Brookhill Road Industrial Estate
Pinxton, Nottingham, UK
NG16 6NT
Voice: [phone]
Email:
[e-mail]
Website:
www.chauvetlighting.co.uk
Chauvet Europe BVBA
Address: Stokstraat 18
9770 Kruishoutem
Belgium
Voice: [phone]
Email:
[e-mail]
Website: www.chauvetlighting.eu
Chauvet France
Address: 3, Rue Ampère
91380 Chilly-Mazarin
France
Voice: [phone]
Email:
[e-mail]
Website: www.chauvetli
g
htin
g
.eu
Chauvet German
y
Address: Bruno-Bürgel-Str. 11
28759 Bremen
Germany
Voice: [phone]
Email:
[e-mail]
Website: www.chauvetlighting.eu
Chauvet Mexico
Address: Av. de las Partidas 34-3B
(Entrance by Calle 2)
Zona Industrial Lerma
Lerma, Mexico C.P. 52000
Voice: +52
(
728
)
690-2010
Email:
[e-mail]
Website:
www.chauvetprofessional.mx
Outside the U.S., U.K., Ireland, Benelux, France, Germany, or Mexico, contact
the dealer of record. Follow the instructions to request support or to return a
product. Visit our website for contact details
D-Fi™ USB Instructions – Rev. 2 ML6
© Copyright 2020 Chauvet
All rights reserved.
Printed in the P. R. C.
5200 N.W. 108th Ave., Sunrise, FL 33351 U.S.A. [phone] – [phone] [e-mail]
The D-Fi™ USB is able to make any product with a D-Fi™ USB Port into a D-Fi™ wireless receiver/transmitter. Further
instructions for connecting and configuring your product for D-Fi™ USB operation are in your product's User Manual.
Instructions
1. Set the DMX Personality and DMX address on your product.
2. Use the Chart provided to set BOTH:
 the Channel, and then
 the Receiving or Transmitting option.
NOTE: DIP Switch 5 is for Transmitting OR Receiving, please choose carefully.
Once plugged in, the D-Fi™ USB will take over the product. Wired DMX, manual displa
y
control / menu buttons and IRC will be unavailable until you unplug the D-Fi™ USB. The
priority levels are:
1. D-Fi™ USB
2. Wired DMX
3. IRC-6 Remote Control
4. Manual Digital Display/Menu Buttons
FCC Compliance
This equipment has been tested and found to comply with the limites for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residual installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
(1) Reorient or relocate the receiving antenna
(2) Increase the separation between the equipment and receiver
(3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
(4) Consult the dealer or an experienced radio/TV technician for help
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This device complies with Part 15 Part B of the FCC rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.