User Manual
TABLE OF CONTENTS 1. Before You Begin .............................................................................. 3 What Is Included ............................................................................................... 3 Unpacking Instructions ...................................................................................... 3 Claims ........................................................................................................................ 3 Text Conventions ..................
1. BEFORE YOU BEGIN What Is Included 1 x Nimbus™ 1 x Power Cord 1 x Warranty Card 1 x Quick Reference Guide Unpacking Instructions Immediately upon receipt, carefully unpack the product and check the container to make sure you have received all the parts indicated above in good condition.
Safety Notes Please read the following Safety Notes carefully before working with the product. The Notes include important safety information about installation, usage, and maintenance. Page 4 of 11 Always connect the product to a grounded circuit to avoid the risk of electrocution. Always disconnect the product from the power source before cleaning. Make sure the power cord is not crimped or damaged.
2. INTRODUCTION Product Overview LED Indicators Carry Handle (x2) Power In Optional Power In Lid Latch Lid Latch (x2) Output Nozzle Operation Output Lever Nimbus™ User Manual (Rev.
Product Dimensions Page 6 of 11 Nimbus™ User Manual (Rev.
3. SETUP AC Power The Nimbus™ has a fixed voltage power supply and can work with an input voltage of either 120 V, 60 Hz or 230 V, 50 Hz, depending on the specific model. To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart. The listed current rating indicates the product’s average current draw under normal conditions.
4. OPERATION Basic Instructions Operation The top plate has two LED indicators – one red and one green. The red LED indicates that the heater is on, and the green LED indicates when the water is at its optimal operating temperature. The heater will not turn on unless there is enough water. As the dry ice sublimates, the green LED indicator will turn off indicating that the water temperature has dropped below its optimal operating temperature.
5. TECHNICAL INFORMATION Maintenance The Nimbus requires minimal upkeep in order to maintain optimum performance. However, some steps are needed in order to clean and maintain the product for maximum usage. The recommended procedure is as follows: 1. After usage, wait for the machine to fully cool down. 2. Dump all water from the internal tank from the product. 3. If there is any water left over, wait until it has cooled down before transporting.
Contact Procedure CHAUVET® Contact Information In case you need to return a product or request support, follow the procedure below: If you live in the US, contact CHAUVET® World Headquarters (see below). If you live in the UK or Ireland, contact CHAUVET® Europe Ltd.(see below). If you live in any other country, DO NOT contact CHAUVET®. Instead, contact your distributor of record. Refer to our Web site for contact details of distributors outside the US, United Kingdom, or Ireland.
6. TECHNICAL SPECIFICATIONS Length Dimensions and Weight 20 in (513 mm) Width 18 in (465 mm) Height Weight 19 in (470 mm) Empty: 28.6 lbs (13 kg) Full: 75 lbs (34 kg) Note: Dimensions in inches rounded to the nearest decimal digit. Power Heat Thermal Ordering Nimbus™ User Manual (Rev. 07) Power Supply Type Range Voltage Selection Model specific 120 V, 60 Hz or 230 V, 50 Hz Voltage specific Parameter Single Element Dual Element Consumption 1500 W 3000 W Operating 12.6 A 25.