User manual

Obey™ 10 User Manual 13 Revised: 2008-08-25 14:33:33
Playback
MANUAL RUN CHASE
When power is first turned ON, the controller will be in manual scene mode.
Action 
1) Make sure neither MUSIC TRIGGER nor
AUTO TRIGGER LED's on the LED
display are on.
2) Select the program CHASE button that
stores the scene you want to run manually
by using the STEP UP/DOWN.
Notes 
If you are in programming mode you can also
press and hold the PROGRAM button until the
Program LED goes off.
RUNNING IN SOUND-MODE
Action 
1) Press the MUSIC/ADD button until the
MUSIC TRIGGER LED turns on.
2) Select the CHASE you wish to operate.
3) Press the MUSIC/BANK-COPY to exit.
Notes 
In the Sound mode, programs will be triggered by
the sound using its built-in microphone. All scenes
in a Bank will chase.
RUNNING IN AUTO-MODE
Action 
1) Press and hold the AUTO/DEL button until
the AUTO TRIGGER LED turns on.
2) Select the CHASE you wish to operate.
3) You can override the time between steps
by moving the SPEED fader and the fade
time of the step by moving the FADE
TIME fader. To revert to the programmed
values, press the PROGRAM button once.
4) You can change Banks while in operation
by using the STEP UP/DOWN buttons.
Notes 
In the Auto mode, programs will be triggered by
controllers fade and speed time as set on the
faders. All scenes in a Bank will chase.
CAUTION! The fade setting should never be
slower than the speed setting or the scene will
never complete execution.
Running Sequential chases
Action 
1) Press either AUTO/DEL or MUSIC/ADD
buttons to select the trigger mode.
2) Press the CHASE button for each chase
you wish to playback.
3) Adjust the Chase speed by changing the
SPEED fader.
Notes 
Chases must already be programmed.
The chases will run in the order they are pressed