User manual

4. Operation | Tips and Tricks
Obey™ 6 User Manual Rev. 1 Page 19 of 22
Tricks
If the Strobe LED does not go off when the board is in Manual mode, try the following:
If the Strobe LED is flashing
1. Press <Strobe> twice or bring <Strobe Speed>
all the way down. The LED will stop flashing
and remain on.
2. Press <Strobe> once. The Strobe LED will turn off.
If the Strobe LED is on continuously
1. Press it once and the LED will turn off.
If the lights seem unresponsive when going into Color Fade, Auto, or Chase mode, try the following:
1. Move <Speed Time> and <Fade Time> to halfway up.
2. Move <Master Dimmer> up and down, and up again to full.
If more than one light is selected, and one of them does not respond to the <Master Dimmer>
fader, do the following:
1. Select only the non-responsive light.
2. Put it in Manual mode
3. If the Strobe LED is on, press <Strobe> to turn the Strobe LED off.
If any of the colors in Preset mode looks less saturated than they should be, press the <White> and
the <UV> Quick Color buttons until the desired saturation is achieved.
If any of the colors in Preset mode looks more saturated than they should be, move the <White>
and <UV> faders up and down until the desired saturation is achieved.
If the lights seem unresponsive in Manual mode, move each fader up and down once.
If the lights go dark when switching between modes, check the <Fade Time> fader and bring it up
all the way.