User manual

Operation
-22- OVATION™ C-640FC User Manual Rev. 4
DMX Personality
Set the DMX personality as follows.
1. Go to the PERS main level.
2. Select the desired personality (TOUR, TR16, ARC.1, AR1.D, ARC.2, ARC.3,
AR3.D, AR3.S, HSV, PIX1, PX16, PIX3).
• See the DMX Control section for the highest starting address you can select for
each personality.
• Make sure that the starting addresses on the various products do not overlap
due to the new personality setting.
DMX Control
DMX Control allows you to assign each product to a unique starting address on the DMX
controller. All products with the same starting address will respond in unison.
1. Select a DMX personality.
2. Set the running mode:
• Go to the RUN main level.
• Select DMX.
Note: For information on the SLAV option, see Master/Slave Mode
.
3. Set the starting address:
• Go to the ADDR main level.
• Select the starting address D.001–D.512.
The highest recommended starting address for each DMX mode is as follows:
DMX
Mode
DMX
Address
DMX
Mode
DMX
Address
DMX
Mode
DMX
Address
TOUR
501
TR16
495
ARC.1
509
AR1.D
508
ARC.2
508
ARC.3
507
AR3.D
506
AR3.S
505
HSV
510
PIX1
505
PIX3
501
PX16
489
Loss of Signal Setting
This setting controls how the product responds when the DMX signal is lost.
1. Go to the SET main level.
2. Select the DERR programming level.
• Select BLAK to turn off the LEDs when the signal is lost.
• Select SAVE to use the last command programmed when the signal is lost.