User manual

PiX™ PAR 12 User Manual Rev. 3 Page 9 of 20
Mounting
Before mounting the product
, read and follow the safety recommendations indicated in
the Safety Notes section (page 2 of this manual).
Orientation
The PiX™ PAR 12
may be mounted in any position; however, make sure adequate
ventilation is provided around the product.
Rigging
• Before deciding on a location for the product, always make sure there is easy
access to the product for maintenance and programming purposes.
• Make sure that the structure or surface onto which you are mounting the product
can support the product’s weight. Please see the Technical Specifications section of
this manual for weight information.
• When mounting the product overhead, always use a safety cable.
Mount the
product securely to a rigging point, whether an elevated platform or a truss.
• When rigging the product onto a truss, you should use a mounting clamp of
appropriate weight capacity. The bracket has a 13 mm hole, which is appropriate for
this purpose.
• When power linking multiple products, you must always consider the length of the
power linking cable and mount the products close enough for the cable to reach.
• The bracket adjustment knobs allow for directional adjustment when aiming the
product to the desired angle. Only loosen or tighten the bracket knobs manually.
Using tools could damage the knobs.
• The double bracket yoke/mounting brackets/rubber feet/metallic feet also serve as
floor supports/allow for surface mounting. When mounting the product
on the floor,
make sure that the product and cables are away from people and vehicles.
Mounting Diagram
Mounting Bracket
Bracket Adjustment Knob