User manual

Operating Instructions
Q-Spot & Q-Spot 150 User Manual 11 2005-11-15/13:11
Note!
If the fixture is connected to a
controller, please disconnect it.
The display will read the previously
selected setting.
Only one fixture can be the Master
assigned fixture. However, 16 units
can be slaved to the master unit.
Important!
P1, P2, and P3 must be set
identically to the Master unit in order
for the Master/Slave mode to
function properly.
Operating Modes
 A stand-alone mode will listen to sound and run through its diverse range of built in programs.
 Master/Slave mode will allow the command of up to as many units you want in a synchronized
light show to the sound.
 DMX control mode will provide the greatest flexibility and creativity. Each fixture trait can be
controlled individually using any universal DMX-512 controller.
Master/Stand Alone
In order to create the correct environment for Stand Alone
operation, several parameters have to be set in the control
panel. Please make the changes to the functions as listed in
the table below.
FUNCTION SET TO NOTES
PA -y Master mode
P8 -y Sound activated
P9 -y Run built-in programs
A 001 Channel address
P5 Any Pan invert
P6 Any Tilt invert
At this stage it is important to notate the following function settings for the Master fixture. It will be
necessary to duplicate these in Slave fixtures.
Master Fixture Settings
Function Notate Setting
P1
P2
P3
Setting Slave Fixtures
The Master/Slave mode will allow you to link multiple units in a daisy chain fashion. In this mode, the
first unit in the daisy chain, the master, will automatically command all other units following. The first
unit will operate in a Stand/Alone mode and all units following will synchronize to the first unit. Up to
16 fixtures can be daisy chained in Master/Slave mode.
MENU SET TO NOTES
PA -n Master mode
P8 -n Sound activated
P9 -n Run built-in programs
A 001 Channel address
P1 Carry over settings from Master Unit
P2 Carry over settings from Master Unit
P3 Carry over settings from Master Unit
P5 Any Pan invert
P6 Any Tilt invert
You can change the Pan and Tilt Invert settings freely.