User manual

Master/Slave Mode (Master Sound, Master Auto):
This mode will allow you to link up to 32 units together without a controller.
1) Use standard DMX cables to daisy chain your units together via the DMX connector on the rear
of the units. For longer cable runs we suggest a terminator at the last fixture. For more
information about terminators, see page 10.
2) Choose a unit to function as the Master. This unit must be the first unit in the line.
3) Press the <MENU> button.
4) Scroll up or down until <3-Operation> is displayed.
5) Press <ENTER>.
6) Press up or down until <select: Auto1>, <select: Auto2>, <select: Music1>, <select:
Music1>,or <select: Random> is displayed.
7) Press <ENTER>.
8) Chain the units together using DMX cable.
9) On the slave units, press the <MENU> button.
10) Scroll up or down until <3-Operation> is displayed.
11) Press up or down until <select: Slave> is displayed.
12) Press <ENTER>.
13) The units will react to the low frequencies of music via the internal microphone in Sound-Active
mode, or the unit will auto change in Auto Mode. In Random mode, the unit will periodically
change between auto and sound-active modes.
DMX Mode
This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with
DMX, please read the DMX Primer on page 22.
1) Press the <MENU> button.
2) Scroll up or down until <3-Operation> is displayed.
3) Press <ENTER>.
4) Press up or down until <select: DMX> is displayed.
5) Press <ENTER>.
Q-Spot 152 User Manual 17 2007-07-09/17:40