User manual

Operation
January 30, 2012 -9- Q-Spot 260-LED User Manual Rev. 02
4. Operation
Control Panel
Description
Button
Function
<MENU>
Exits from the current menu or
function
<ENTER>
Enables the currently displayed
menu or sets the currently
selected value in to the current
function
<UP>
Navigates upwards through the
menu list and increases the
numeric value when in a function
<DOWN>
Navigates downwards through
the menu list and decreases the
numeric value when in a function
Control Options
You can set the Q-Spot 260-LED start address in the 001~512 DMX range. This allows
for the control of up to 36 fixtures in the 14-channel ADVANCED DMX mode and up to
46 fixtures in the 11-channel BASIC DMX mode. The Q-Spot 260 LED does not
support ID Addressing.
Programming
Carry out all the programming procedures indicated below from the control panel. Refer
to the Menu Map page to learn how the menu options relate to each other.
Use <ENTER> and <MENU> to change levels in the Menu Map. This is equivalent to
move right and left respectively. Use <UP> and <DOWN> to move vertically within the
Menu Map options.
DMX Operation
1) Select DMX operation
a) Go to MENU > INTRO > RUN
b) Select DMX512
2) Select a DMX mode
a) Go to MENU > INTRO > CHANNELS
b) Select BASIC or ADVANCED
3) Select the starting address
a) Go to MENU > INTRO > ADDRESS
b) Select a starting address, 001 ~ 498 (Advanced) or 001~501 (Basic)
Stand-alone
Operation
1) Go to MENU > INTRO > RUN
2) Select a stand-alone operation mode (AUTO 1, AUTO 2, SOUND 1, SOUND 2,
CUSTOM or TEST)
Master/Slave
Operation
1) Configure the Master fixture
a) Select a stand-alone mode, as indicated above
2) Configure the Slave fixtures
a) Go to MENU > INTRO > RUN
b) Select SLAVE
Of all the stand-alone operation modes indicated above, only “CUSTOM” is
editable (see Edit Custom).
Display Mode
1) Go to MENU > INTRO > DISPLAY
2) Select a display mode (60 CLOSE or BRIGHT)
When in the “60 CLOSE” setting, the display backlight will turn off after 60 s.
When in the “BRIGHT” setting, the display backlight will stay on.
Software Version
1) Go to MENU > INTRO > INFO
2) The display will show the installed software version.