User manual

Operation
Q-Spot 260-LED User Manual Rev. 02 -10- January 30, 2012
Keylock
1) Go to MENU > INTRO > KEYLOCK
2) Select YES or NO
When in the “YES” setting, the user will have to enter the password after 30
seconds of control panel inactivity or each time he/she turns the fixture on.
The default (non-modifiable) password is <UP>, <DOWN>, <
UP>, <DOWN> and
<ENTER>.
Movement Inversion
1) Go to MENU > INVERT > PAN
2) Select a movement mode (NORMAL or REVERSE)
3) Go to MENU > INVERT > TILT
4) Select a movement mode (NORMAL or REVERSE)
5) Go to MENU > INVERT > USE
6) Select YES to activate the new settings or NO to stop using them.
Color Wheel
Movement
1) Go to MENU > INVERT > COLOR
2) Select a movement mode (STEP or LINEAR)
3) Go to MENU > INVERT > USE
4) Select YES to activate the new setting or NO to stop using it.
Edit Custom
1) Go to MENU > EDIT > STEP
2) Select a programming step (000~255)
3) Go to MENU > EDIT > PAN
4) Select a pan value (000~255)
5) Go to MENU > EDIT > TILT
6) Select a tilt value (000~255)
7) Go to MENU > EDIT > XY SPEED
8) Select a tilt/pan movement speed (000~255)
9) Go to MENU > EDIT > COLOR
10) Select a color wheel position (000~255) as per the DMX Values table
11) Go to MENU > EDIT > GOBO 1
12) Select a fixed gobo (000~255) as per the DMX Values table
13) Go to MENU > EDIT > GOBO 2
14) Select a rotating gobo (000~255) as per the DMX Values table
15) Go to MENU > EDIT > GOBO 2 ROT
16) Select a rotating gobo mode (000~255) as per the DMX Values table
15) Go to MENU > EDIT > PRISM
16) Select a rotating prism mode (000~255) as per the DMX Values table
17) Go to MENU > EDIT > FOCUS
18) Select a focus position (000~255)
19) Go to MENU > EDIT > DIMMER
20) Select a dimmer setting (000~255)
21) Go to MENU > EDIT > STROBE
22) Select a strobe setting (000~255) as per the DMX Values table
23) Go to MENU > EDIT > TIME
24) Select the duration of this step (000~255)
25) Go to MENU > EDIT > USE
26) Select YES to save the settings for this step or NO to delete them.
27) Repeat steps “3” to “26” for the other steps
To repeat the Custom steps in an endless loop mode, configure the “TIME”
setting of the last step as “0”.