User manual
Setup
Rogue™ R1 Spot User Manual Rev. 5 -9-
Mounting
Before mounting this product, read and follow the Safety Notes. For our CHAUVET® line of
mounting clamps, go to http://trusst.com/productcategory/base-plates-accessories-clamps/.
Orientation
Always mount this product in a safe position and make sure there is adequate room for
ventilation, configuration, and maintenance.
Rigging
CHAUVET® recommends using the following general guidelines when mounting this product.
• When selecting an installation location, consider easy access to this product for operation,
programming adjustments, and routine maintenance.
• Make sure to mount this product away from any flammable material as indicated in the
Safety Notes
.
• Never mount in places where rain, high humidity, extreme temperature changes, or
restricted ventilation may affect the product.
• If hanging this product, make sure that the mounting location can support the product’s
weight. See the Technical Specifications
for the weight-bearing requirements of this
product.
• When hanging this product, always secure to a fastening device using a safety cable (such
as CH-05 from CHAUVET®).
Procedure
The Rogue™ R1 Spot comes with a preinstalled mounting surface to which you will be able to
attach the 2 included omega brackets. Make sure the clamps (such as CLP-15 from
CHAUVET®) are capable of supporting the weight of this product. Use two mounting points per
product. In addition, use a safety cable to link the product to the structure.
Mounting Diagram
Floor Mounting
Overhead Mounting
Omega Brackets
Safety Cable
Mounting Clamp
Mounting
Surface