User manual
Operation
Rogue™ R1 Spot User Manual Rev. 5 -13-
Address
This programming level sets the DMX starting address.
•
Starting from the Main Level screen, select Address, press <ENTER>.
Set the
DMX Address
In this mode, each product will respond to a unique starting address from the DMX
controller. All products with the same starting address will respond in unison.
This option
sets the products DMX address.
• Change the starting address (001–512), press <ENTER>.
Run Mode
This programming level sets the DMX personality and controls the different test modes.
• Starting from the Main Level screen, select Run Mode, press <ENTER>.
DMX Personality
This option selects which DMX Personality the product uses.
1. Highlight DMX, press <ENTER>.
2. Select the DMX personality 16CH or 19CH, press <ENTER>.
• See the DMX Values section for the highest starting address you can select for
each personality.
• Make sure that the starting addresses on the various products do not overlap
due to the new personality setting.
Auto Test
This option runs every attribute individually through 1 cycle.
• Highlight Auto Test, press <ENTER>.
The Auto Test will end after 1 full cycle. You can stop the test by pressing <MENU>
at any time.
Manual Test
This option allows you to run each attribute individually or as a group.
1. Highlight Manual Test, press <ENTER>.
2. Highlight the desired attribute listed on the control panel screen, press <ENTER>.
• Set the attribute value (000–255), press <ENTER>.
3. Repeat step 2 for the other attributes.
When exiting the Manual Test level, the values of all tested channels will go back
to zero.