User manual

Stage Designer™ 50 11 Rev. 9
Erase a Program
Action ·
1. Record enable.
2. Use the Page button to select the page the
Scene you wish to erase is on.
3. Press and hold the Edit button & tap the
Flash button (13-24) twice of the Scene you
wish to erase.
4. Release the 2 buttons. The LED for the
corresponding program should light,
indicating that it has been selected.
5. Press the Delete button. All LEDs should
light, indicating the program is erased.
Notes ¥
Erase all Scenes
Action ·
1. Record enable
2. Press and hold RECORD.
3. While holding Record button, tap the flash
buttons in the following sequence: 1-3-2-3.
Release the Record button.
4. All LEDs should light, indicating all
programs have been erased.
5. Press and hold RECORD & REC EXIT to
exit the mode.
Notes ¥
You must be in Record mode to Reset the
controller.
The LED over the Record button will light,
indicating the Record mode operation.
Warning: this will reset the controller to its factory defaults. This will erase all programs and settings.
Record Clear
Action ·
1. Record enable.
2. Record a scene with 1 or more steps.
3. If you are not satisfied with the scene, you
may press and hold the Record button &
tap the Page/REC CLR button. All LEDs will
flash, indicating the scenes have been
cleared.
Notes ¥
All scenes stored in the temporary memory of the
controller will be erased by this process.
This process will not affect the scenes already
programmed into a Scene fader.