TFX-950CM Stage Wash™ 950 USER MANUAL Chauvet, 3000 N 29th Ct, Hollywood, FL 33020 U.S.A (800) 762-1084 – (954) 929-1115 FAX (954) 929-5560 www.chauvetlighting.
TABLE OF CONTENT BEFORE YOU BEGIN ...................................................................................................................................................... 3 WHAT IS INCLUDED................................................................................................................................................................................ 3 UNPACKING INSTRUCTIONS ..........................................................................................................
BEFORE YOU BEGIN What is included 1 x Stage Wash™ 950CM (TFX-950CM) Power cord with plug 3 x EHM 300w 120v or 3 x EHM2 300w 230v lamps Warranty Card & Manual Unpacking Instructions Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition.
INTRODUCTION Features 2-4 channel DMX RGB color wash fixture Operating modes: RGB Mode: Full RGB mix plus dimmer (4 channels) C&B Mode: Color selection (40 presets) and dimmer (2 channels) RGB & Chase Mode: 7 distinct operating modes (4 channels) - RGB mix, 8-pattern auto, 8-pattern sound, auto-chase, sound-chase, 40-color auto or sound Individual channel controls may include; - Red 0-100%, color selection or mode select - Green or Red 0-100%, dimmer 0-100% - Blue or Green 0-100%, fad
Introduction Product Overview LED status window DMX channel values and brief instructions Control panel buttons DMX Input connector DMX Output connector TFX-950CM User Manual Fan Sound sensitivity knob Built in microphone IEC power connector for power cable Foot controller connector for TFX-SWF 5 Voltage Selector Switch Fuse compartment Revision: 2006-01-20/16:37
SETUP Lamp You will need to install a lamp prior to the initial operation of the fixture. Three EHM 300W halogen lamps are included. Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the unit to cool down! Always disconnect from main power prior to lamp replacement. Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp with alcohol and wipe it with a lint free cloth before installation.
Setup Mounting O RI E NT AT IO N This fixture may be mounted in any position provided there is adequate room for ventilation. RIG G ING Hanging Clamp It is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After finding the desired position, retighten both knobs.
OPERATING INSTRUCTIONS Operating Modes The TFX-950CM can be operated in three ways. A stand-alone mode will listen to sound and run through its diverse range of built in programs. An optional TFX-SWF wired controller provides simple remote control. Master/Slave mode will allow the command of up to as many units you want in a synchronized light show to the sound. DMX control mode will provide the greatest flexibility and creativity.
Operating Instructions Master/Slave The Master/Slave mode will allow you to link up to as many units you want in a daisy chain fashion. In this mode, the first unit in the daisy chain will automatically command all other units following. An optional TFX-SWF controller connected to the first unit in the chain will allow enhanced control functions. M AST E R/ S L AV E S ET T ING S 1) Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first fixture.
Operating Instructions RG B &D M O DE All three lamps are individually dimmable giving the user the ability to customize or create the color of choice. This mode offers the user complete freedom. 1) A steady hold of the MODE button will change the operating mode once then release the button. Channel Function 1 Red 2 Green 3 Blue 4 Dimmer 2) Repeat step 1 until you arrive at the RGB&D operating mode, as indicated by the led next to the label.
Operating Instructions TFX-SWF Easy Controller (Optional) The TFX-SWF Foot Controller is used only in master/slave mode. Connect the 8-pin connector of the foot controller into its respective connector on the first unit in the daisy chain. The table below describes the functions of the TFX-SWF Controller.
APPENDIX DMX Primer There are 512 channels in a DMX-512 connection. Channels may be assigned in any manner. A fixture capable of receiving DMX 512 will require one or a number of sequential channels. The user must assign a starting address on the fixture that indicates the first channel reserved in the controller. There are many different types of DMX controllable fixtures and they all may vary in the total number of channels required. Choosing a start address should be planned in advance.
Appendix DMX Channel Values RGB&D Mode (RGB and Dimmer) Channel Value Function 1 000 255 2 000 255 3 000 255 4 000 255 Red Intensity: 0% ~ 100% Green Intensity: 0% ~ 100% Blue Intensity: 0% ~ 100% Dimmer 0 100% Notes C&B Mode (Color and Brightness) Channel Value Function Notes 1 000 255 See Color Mix table on the next page 2 000 255 Spectrum Color Mix See Color Mix Table Dimmer Intensity: 0% ~ 100% RGB and Chase Mode Mode RGB Mode 8 Built-in Programs (Auto) 8 Built-in P
Appendix Color Mix Table (Preset) DMX Value Green Intensity 0% ~ 100% 0 Blue Intensity 0% ~ 100% 0 Notes 0 Red Intensity 0% ~ 100% 0 1 2 100 100 0 0 0 0 Red @ Full only 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 3 6 9 12 15 18 21 24 27 30 33 36 39 42 45 48 51 54 57 60 63 66 69 72 75 78 81 84 87 90 93 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Appendix 57 58 59 60 61 62 63 64 65 31 28 25 22 19 16 13 10 7 100 100 100 100 100 100 100 100 100 0 0 0 0 0 0 0 0 0 Green @ Full Proportional Red 66 67 68 69 0 0 0 0 100 100 100 100 0 0 0 0 Green @ Full only 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 3 6 9 12 1
Appendix 119 120 121 122 123 124 125 126 127 128 129 130 131 132 0 0 0 0 0 0 0 0 0 0 0 0 0 0 46 43 40 37 34 31 28 25 22 19 16 13 10 7 100 100 100 100 100 100 100 100 100 100 100 100 100 100 Blue @ Full Proportional Green 133 134 135 136 0 0 0 0 0 0 0 0 100 100 100 100 Blue @ Full only 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 3 6 9 12 15 18 21 24 27 30 33 36 39 42 45 48 51 54 57 60 63 66 69 72 75 78 81 84 87 90 93
Appendix 181 182 183 184 185 186 187 188 189 190 191 192 193 194 195 196 197 198 199 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 61 58 55 52 49 46 43 40 37 34 31 28 25 22 19 16 13 10 7 Red @ Full Proportional Blue 200 201 202 203 204 205 206 100 100 100 100 100 100 100 6 12 18 24 30 36 42 12 24 36 48 60 72 84 Red @ Full Proportional Green and Blue 207 100 50 100 Red & Blue @ Full, Green @ 50% 208 209 210 88 76 64 62 74 8
Appendix 234 235 236 237 238 239 240 241 242 243 244 245 246 247 248 249 250 251 88 76 64 50 44 38 32 25 19 13 7 12 18 24 31 37 43 49 44 38 32 25 19 13 7 12 18 24 30 36 42 48 62 74 86 98 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 Blue @ Full Proportional Red and Green 252 253 254 62 74 86 100 100 100 100 100 100 Blue and Green @ Full Proportional Red 255 100 100 100 Red,Green,Blue @ FULL (White) Maintenance To maintain optimum performance and minimize wear fixtur
Appendix Returns Procedure Returned merchandise must be sent prepaid and in the original packing, call tags will not be issued. Package must be clearly labeled with a Return Merchandise Authorization Number (RA #). Products returned without an RA # will be refused. Call CHAUVET and request RA # prior to shipping the fixture. Be prepared to provide the model number, serial number and a brief description of the cause for the return.
Appendix General Troubleshooting Applies to Foggers & Snow Dimmers& Chaser Symptom Solution(s) Auto shut off Check fan thermal switch reset Beam is very dim or not bright Clean optical system or replace lamp Check 220/110v switch for proper setting Breaker/Fuse keeps blowing Check total load placed on device Chase is too slow Check users manual for speed adjustment Device has no power Check for power on Mains. Check device’s fuse.
Appendix Technical Specifications WEIGHT & DIMENSIONS Length........................................................................................................................... 305 mm (12 in) Width...............................................................................................................................229 mm (9 in) Height .............................................................................................................................152 mm (6 in) Weight.............