User manual

Appendix
TFX-D6 User Manual 12 2005-04-20/11:20
Preheat [Preheat]
Enabling the preheat function will protect your lamps against cold starts. Upon powering the dimmer a
trickle voltage will be output to the lamps, not enough for the lamp to be visible by the human eye, but
enough to warm up the filament. This will help increase the life of your lamps. Usually 6% of 100%
output is sufficient.
Action 
1) Press the MENU button to enter the setup
menu.
2) Press the UP and DOWN buttons to scroll
menu items until you reach [Preheat].
3) Press MENU button to enter the sub-menu.
4) Press the UP/DOWN buttons to choose
between [All] and [Chan]/Single Channel
mode.
5) Press MENU to select mode.
ALL [All]
1) Press UP/DOWN to select the preheat
value between [000%] – [050%] for all
channels.
SINGLE CHANNEL [Chan [?]]
1) In [Chan [1]]/Single Channel mode press
MENU to change between the channel and
its’ start address as noted by the cursor.
2) In [Chan], press UP/DOWN buttons to
select channels 1~6. In [001], press
UP/DOWN buttons to select percentage
[000%-050%].
3) Repeat steps 1 thru 2 for any additional
channel you would like to change.
4) Press the ESC button to exit and confirm.
Preheat
All
Chan [1]
[000%]
All
[005%]
Chan [1]
[050%]