User manual

4. OPERATING INSTRUCTIONS

Stand-Alone Mode (Sound-Active, Auto Mode):

This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto

Mode.

1) Set dipswitches position, as desired, using the below values.

Dipswitches Function

1 Speed of effect 1

2 Speed of effect 2

3 Speed of effect 3

4 Speed of effect 4

5 Strobing speed 1

6 Strobing speed 2

7 Strobing speed 3

8 All On

9 Sound standalone mode

10 Auto standalone mode

Note: The Speed of effect and strobing effect dipswitches affect the auto programs. The

strobing dipswitches work on their own when all other dipswitches are turned off and there

is no dmx signal present. Also, when you combine the dipswitches for the speed and/or

strobe, they stack together for greater speeds.

2) The unit will react to the low frequencies of music via the internal microphone in Sound

Active mode, or the unit will auto change in Auto Mode.

3) Use the audio sensitivity knob on the back of the unit to make the unit more or less

sensitive in Sound-Active mode. Turning the knob counterclockwise decreases the

sensitivity; turning the knob clockwise increases the sensitivity.

This fixture will automatically recognize master slave operation when connected properly. The

first fixture will be set as the master, and all fixtures following this will set as slave fixtures. You

must follow daisy-chain configuration for this type of setup.

Note: Do not connect a DMX controller to the fixture(s) when you are trying to run

them standalone, as this will put them in DMX mode automatically.

DMX Mode

This mode allows the unit to be controlled by any universal DMX controller. This fixture will

automatically switch to DMX mode when you connect a DMX controller to it. If you are unfamiliar

with DMX, please read the DMX Primer section.

Vue™ 1.1 User Manual 10 6/11/2008 9:28 AM