Footswitch (LED-FS1) User Manual
TABLE OF CONTENTS 1. Before You Begin................................................................................3 What Is Included ........................................................................................... 3 Unpacking Instructions .................................................................................. 3 Claims ................................................................................................................... 3 Text Conventions ...............................
1. BEFORE YOU BEGIN What Is Included • • 1 x COLORstrip™ Footswitch (LED-FS1) 1 x 10 ft 6-pin DIN cable • • 1 x Warranty Card 1 x User Manual Unpacking Instructions Immediately upon receipt, carefully unpack the product and check the container to make sure you have received all the parts indicated above in good condition.
Product at a Glance Use on Dimmer x Outdoor Use x Sound-Activated x DMX x x Master/Slave Safety Notes Duty Cycle x x x x x Please read the following Safety Notes carefully before working with the product. The Notes include important safety information about installation, usage, and maintenance. • • • • • Always connect the product to a grounded circuit to avoid the risk of electrocution. Always disconnect the product from the power source before cleaning.
2. INTRODUCTION Product Overview 6-pin DIN cable connection (rear) Power Indicator LED Scene Button Speed Button Function Button Blackout Button COLORstrip™ Footswitch User Manual Rev.
3. SETUP Power The input power for the Foot Controller is provided by the COLORstrip™ product being used. The included 6-pin DIN cable provides both power and signal between the controller and the product. To determine the COLORStrip’s power requirements (circuit breaker, power outlet, and wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart.
4. OPERATION Foot Controller Functions The COLORstrip™ Foot Controller provides quick access to the COLORstrip’s built-in programs, blackout function, static colors, strobe speed, and chase programs. Please refer to the Product Overview to see the button locations on the Foot Controller. Button <1> Scene <2> Speed <3> Function <4> Blackout Speed <2> Button Functions Table Function This button allows the user to cycle through the stand-alone programs in the COLORstrip™ product.
5. TECHNICAL INFORMATION Product Maintenance To maintain optimum performance and minimize wear, you should clean your products at least twice a month. However, be aware that usage and environmental conditions could be contributing factors to increase the cleaning frequency. To clean the product, follow the instructions below: • Unplug the product from power. • Wait until the product is at room temperature.
Contact Procedure CHAUVET® Contact Information In case you need to return a product or request support, follow the procedure below: • • • If you live in the U.S., contact CHAUVET® World Headquarters (see below). If you live in the UK or Ireland, contact CHAUVET® Europe Ltd.(see below). If you live in any other country, DO NOT contact CHAUVET®. Instead, contact your distributor of record. Refer to our website for contact details of distributors outside the US, United Kingdom, or Ireland.
6. TECHNICAL SPECIFICATIONS Dimensions and Weight Length Width Height Weight 15.8 in (401 mm) 7 in (179.2 mm) 3 in (74.8 mm) 5 lbs (2.3 kg) Note: Dimensions in inches rounded to the nearest decimal digit. Thermal Maximum External Temp. 104° F (40° C) Ordering Page 10 of 10 Product Name Item Code Item Number COLORstrip Footswitch 02080189 LED-FS1 COLORstrip™ Footswitch User Manual Rev.