User manual

Setup
8 Xeno™ 2500 User Manual Rev. 1
4. Side B contains 2 wires (1- white and 1 clear) that are connected to a terminal block.
Unscrew these wires and carefully note where each was connected. CAUTION: Do
not misalign or reverse the connections when installing the new lamp!
5. Using the ceramic ends of the lamp, carefully remove it from the socket springs.
6. Holding ONLY the ceramic ends of the lamp and using EXTREME CAUTION not to
touch the glass portion of the lamp, gently slide the lamp into the socket spring
located on Side B.
7. Reverse the steps 2 through 4 above to install the new lamp.
Increasing the Lamp’s
Life
• DO NOT touch the lamp without wearing gloves to avoid leaving grease on the
bulb or on the contacts that could reduce the lamp’s life.
• ALWAYS change the lamp when it has reached its recommended lifespan to
avoid the risk of lamp explosion.