Instructions

23
14-2 Storage
If the multimeter is not put into service for a time exceeding 60 days,
remove the batteries and store them separately.
14-3 Cleaning
■ The multimeter must be disconnected from any electrical source.
■ To clean the case, use a cloth slightly moistened with soapy water.
Rinse with a damp cloth. Then, dry rapidly with a cloth or in a hot
air stream.
14-4 Metrological check
It is essential that all measuring instruments are
regularly calibrated.
For checking and calibration of your instrument, please contact our
accredited laboratories (list on request) or the Chauvin Arnoux
subsidiary or Agent in your country.
14-5 Repair
Repairs under or out of guarantee: please return the product to
your distributor.
14 - MAINTENANCE
For maintenance, use only specified spare parts.
The manufacturer will not be held responsible for
any accident occurring following a repair done other
than by its After Sales Service or approved repairers.
14-1 Replacing the battery and the fuses
For your safety the leads must be disconnected from the
multimeter before the battery cover is opened.
■ To open the cover, turn the screw 1/4 turn, anti-clockwise, using
a coin or a screwdriver.
■ Replace the dead battery by one 9 V battery (type 6F22 or 6LF22)
■ Replace the faulty fuses respecting their value and their type:
- Fuse 1 A HBC (6.3 x 32 mm - 500 V - 10 kA)
- Fuse 10 A HBC (10 x 32 mm - 500 V - 10 kA)
■ Refit the cover before using the multimeter.