Owner's manual

2
1.0 INTRODUCTION
DCF-3000EZ = For measurement on steel / iron
DCFN-3000EZ = For measurements on steel / iron and on
non-ferrous metals
The Check•Line 3000EZ Series of coating thickness gauges provide
accurate, non-destructive measurement of:
• All non-magnetic coatings, such as varnish, paint, enamel,
chromium, copper, zinc, etc. on steel and iron. Measurements
in the F mode (Ferrous) are carried out according to the
Magnetic-Induction method.
• All electrically insulating coatings, such as varnish, paint, enamel
on non-ferrous metals (aluminum, brass, stainless steel, etc).
Measurments in the N mode (Non-ferrous) are carried out
according to the Eddy-Current method.
NOTE: 3000EZ Series gauges operate in accordance with the
following international standards related to coating thickness
measurment:
Magnetic Induction
DIN EN ISO 2178, ASTM B499, DIN 50 982
Eddy-Current:
DIN EN ISO 2360, ASTM D1400
15
10.0 ERROR MESSAGES
Error 1 = The probe is too close to the metal
Error 2 = Error of gauge due to the effect of electro-magnetic
interference fields
Error 3 = The probe is defective
For Technical Assistance contact:
Electromatic Equipment Company
Telephone: [phone] (USA & Canada)
1-516-295-4300
Fax: [phone]
Email: [e-mail]
2
1.0 INTRODUCTION
DCF-3000EZ = For measurement on steel / iron
DCFN-3000EZ = For measurements on steel / iron and on
non-ferrous metals
The Check•Line 3000EZ Series of coating thickness gauges provide
accurate, non-destructive measurement of:
• All non-magnetic coatings, such as varnish, paint, enamel,
chromium, copper, zinc, etc. on steel and iron. Measurements
in the F mode (Ferrous) are carried out according to the
Magnetic-Induction method.
• All electrically insulating coatings, such as varnish, paint, enamel
on non-ferrous metals (aluminum, brass, stainless steel, etc).
Measurments in the N mode (Non-ferrous) are carried out
according to the Eddy-Current method.
NOTE: 3000EZ Series gauges operate in accordance with the
following international standards related to coating thickness
measurment:
Magnetic Induction
DIN EN ISO 2178, ASTM B499, DIN 50 982
Eddy-Current:
DIN EN ISO 2360, ASTM D1400
15
10.0 ERROR MESSAGES
Error 1 = The probe is too close to the metal
Error 2 = Error of gauge due to the effect of electro-magnetic
interference fields
Error 3 = The probe is defective
For Technical Assistance contact:
Electromatic Equipment Company
Telephone: [phone] (USA & Canada)
1-516-295-4300
Fax: [phone]
Email: [e-mail]