Manual

AWS-4050 Guide
3-3 Reset All
CLR: Followed by ENT clears all readings and all sets. Should be used
approximately every 5000 readings.
DESCRIPTION OF FUNCTIONS
The following is a description of the standard features of the AWS product line.
OPERATING MODE
Current operating mode (Peak, 1st Peak or Track) will show on the display.
Press the Πkey to toggles between them.
Peak
Displays and retains the maximum torque experienced by the wrench, as
occurs when operating the wrench in the tightening direction. The Peak Mode
is used for all power tools and some dial wrenches.
1st Peak
Detects the “first peak” of torque experienced by the wrench, capturing the
initial torque as occurs when the torque wrench cams over. First Peak is used
primarily for Click torque wrenches and cam over screwdrivers.
Track
Displays torque as it is being applied to the transducer. Track mode is used
primarily for verifying calibration of the unit.
SELECTING A TRANSDUCER
IMPORTANT NOTE: On power-up, the transducer that is selected will be active
and ready to use. When changing the shaft, you MUST Zero the unit. Do this
by pressing the On/Zero. The shaft capacity can be verified by going to the
Information screen in the Systems Menu (2-4). Full Scale capacity screen is
shown. Press the ENT button twice to return to the run mode.
ENGINEERING UNITS
Shows the current engineering units. Press the key to cycle through