Instruction Manual

Measured value is divided by 2

There are two versions of the DT-209X,

Standard Version DT-209X is set for 6 inch

circumference wheel, and DT-209X-S12 is set

to 12-inch circumference wheel. Check the

front label for proper wheel attachments.

While storing values it shows "CCCCC"

The memory button was pressed for 5

seconds.

Could not measure Yards, feet, inches and meters per

minute

These linear rate measurements are availab

in cont

act mode using the wheel attachment.

Could not measure length

These measurements are available in contact

mode, using the wheel attachment.

Check battery orientation and reinstall.

Check the trig

the table immediately.

Different USB port. For every USB port that

will be used, the USB driver is required to be

installed.

Brand new batteries no display.

While using the software, could not see values stored on

ger setting values.

Found new hardware icon appears every time the DT-

209X is plugged in to the computer. (Even after previous

installation of USB driver was successful.)