Instruction Manual

4
Unit Selector Switch
Multi-mode capability measures RPM, mPM, YPM, FPM, IPM and total meters,
yards, feet and inches.
NOTE: Selector switch not available in USB mode; all controls are
transferred to the software through the USB cable.
Measurement
method
Explanation of Operation
Contact measurement requires the contact adapter
(DT-ADP-200L) and the proper attachments.
NOTE: Make sure that proper position of the knob is
selected. For length and linear rate measurements
wheel is required to get right ratio. (FPM-6, FPM-12).
For rotational
speed
measurements
RPM (rev/MIN) –Cone tip, Funnel tip
For speed
measurements
m/MIN - yd/MIN - ft/MIN - in/MIN
(6” or 12” circumference wheel).
Contact Type
For length
measurements
in / ft / yd / m (6” or 12”
circumference wheel)
Non-contact measurement requires the use of the
laser and a reflective tape. Choose the correct
settings with the Unit Selector Switch.
CAUTION: Laser Beam Radiation. Do not stare
into beam.
Non-Contact Type
rotational
speed
measurement
RPM (rev/MIN)