Owner manual

20
4.5 Parameter Setting Instruction
Press “MODE” until the LCD displays “P” (Parameter setting mode).
Press the “SET” key to cycle between the various parameter settings available (range, trigger edge, delay time,
and LCD backlight). For more information regarding the various parameter settings, please refer to sections 4.5.2
through 4.5.4 below. Press the “MODE” key again to store the settings and return to measuring modes.
Note: “MODE” key must be pressed to store settings.
Operation Expression
Measuring range setting
(Press “+”, “-“ key or turn
the dial to switch the
measuring range)
Press to cycle
between parameters
Trigger edge setting
(Press “+”, “-“ key or turn
the dial to change the
trigger edge setting)
FLASH
SET
SET
Auto Range
Trigger
Edge Deley Deg
Flash Time
Ave Last Min Max
min
sec
hHz
○
○○
○
Auto Range
Trigger
Edge
Deley Deg
Flash Time
Ave Last Min Max
min
sec
hHz
○
○○
○
Auto Range
Trigger
Edge
Delay Deg
Flash Time
Ave Last Min Max
min
sec
hHz
○
○○
○
ms
Auto Range
Trigger
Edge
Delay Deg
Flash
Time
Ave Last Min Max
min
sec
hHz
○
○○
○
ms
SET
FLASH
PHASE+
Press to change
the selected
parameter setting
OR
Rotate the dial to
change
the selected
parameter setting
Auto Range
Trigger
Edge
Delay Deg
Flash Time
Ave Last Min Max
min
sec
hHz
○
○○
○
ms
LCD backlight
(Press “+”, “-“ key or turn the
dial to change the backlight
settings)
SET
SET
MODE
Set and store parameter settings
PHASE-
PHASE+
PHASE-
Delay angle setting
(use dial o
r PHASE keys to
change settings
Delay time setting
(Use dial or PHASE keys to
change settings)