Owner manual

Model ESM301 / ESM301L Version 2 Test Stand User’s Guide
16
UNITS: in/min
KEYS: maintained
PASSWORD: 0000 (off)
Default setting: off
Available settings: off, on
Label Description
+ or –
Cycles through the available settings
ENTR
Returns to the Test Parameter Setup menu
ESC
Exits the parameter without saving changes
4.16 Password (NEW PWORD)
If desired, a password can be set to prevent unwanted changes to test parameters. The password can be
set to any number between 0000 and 9999. The default setting of 0000 indicates that the password is
disabled, and that the user can freely enter the Test Parameter Setup menu. If misplaced or forgotten, the
password may be reset through a code activation process. Details on this may be found in Section 9.
Default setting: 0000 (off)
Available settings: 0000 – 9999
Label Description
+ or –
Cycles through the available settings
ENTR
Returns to the Test Parameter Setup menu
ESC
Exits the parameter without saving changes
5 OPERATING MODES
5.1 Mode Overview
The ESM301 can be operated in several modes, including combinations of these modes:
1. Basic Mode
Manual control of crosshead motion.
2. Auto Return Mode
Crosshead moves to a limit switch or force set point, travel distance, preload, or sample
break (referred to as soft limits), whichever occurs first. Then, it reverses and moves at
maximum speed to the other limit, whichever occurs first.
3. Cycling Mode
Crosshead cycles between limits at the selected speed(s), and pauses at each limit or set
point for a selected period of time.
4. Preload Mode
Crosshead moves until the preload has been reached, and performs the action programmed
in the setting. An auto-return, cycle/dwell time, or break detection sequence may follow.
D E F A U L T ? : N O
E S C − + E N T R
N E
W
P
W
O R D 0 0 0 0
E S C − + E N T R