Manual

- 3 -
2.0 MULTIFUNCTIONAL DISPLAY
1. Active reference indicator (REFI or REFII)
2. Measured value
3. Battery life warning display
4. Indicating cursor for preset
5. Unit of measurement indicator
06. Locked mode indicator
07. Hold indicator
08. Display .0005/.00005 INCH
09. Preset indicator
10. Preset mode indicator
3.0 FUNCTIONS
3.1 How to use buttons
3.2 Operation
Press for less than 1 second to activate button function.
Press for more than 1 second to activate mode change.
Mode
< 1sec < 1sec
Mesure
Preset
mm inch Set
Digit = digit + 1
Ref I Ref II
References
> 1sec > 1sec
Off
Off
On
= 1sec
DIR RES
MODE0 MODE1
On
MODE
SET MODE SET
Incr. digit
0.1.2...9
-000.123
Data out, hold
> 3 sec
RESET
(MODE 1, 2, 3)
- 10 -
8.0 SPECIFICATIONS
Measuring range 0-12.5 mm / .5"
0-25 mm / 1"
Resolution 0.001 mm / .00005" (0.01 mm / .0005")
Accuracy 5µm (.0002") / 10µm (.0004")
NOTE: The accuracy is guaranteed only when the dial
gauge is attached to the clamping shaft.
Repeatability 2µm or .0001" (+/-2s)
Max. probe travel speed 1.5 m/sec.
Number of measurements
per second
0.01 mm 8 measurements/sec.
0.001 mm 5 measurements/sec.
Measuring force 0.6 to 1.1 N for 0-25 mm (1")
0.7 to 0.95 N for 0-12.5 mm (.5")
Units of measurement metric/imperial (inch) (direct conversion)
Maximum preset ±2999.99 mm / ±89.9995 in.
Measuring system SYLVAC system (patented).
Display Digital LCD
sign (–), 6 digits (7 in.) height 8.5 mm,
(0.05 mil in inch), display of unit and operating mode.
Power 1 lithium battery 3 V, type CR2032, capacity 190 mAh.
Battery types Toshiba CR2032 / Maxell CR2032
Renata B/CR2032 / Sanyo CR2032
Ucar CR2032 / Panasonic CR2032
Rayovac CR2032 / Varta CR2032.
Power consumption 60 µA.
Battery life 1 year or > 3000 hours with normal use When “B” is
displayed, the remaining battery life is several hours.
Working temperature +5 to +40 °C.
Data output RS232 compatible format.
Interface RS232 interface cable, with optical coupling.
Construction aluminium case, polyamide rotating dial (270°),
hardened and ground stainless-steel measuring spindle
Clamping lower bushing diameter 8 h6 mm .
Contact point M 2.5 interchangeable.
Protection IP 51 (according to IEC 529).
Weight 130 g.
Accessories OPTO-RS232 connector, 2m cable, duplex connection
for PC-AT (Dsub 9p) External power supply
(+5.0Vdc to +12.0 Vdc), binder connector 719 (3p)