Owner's manual

ManualsBrandsCheckline ManualsOptical devicesLS-18-LED

– 1 –

Table of Contents

1.0 Introduction ............................................................................................................... 02

1.1 Unpacking

1.2 Optional Accessories

2.0 Safety Information .................................................................................................... 3

3.0 Controls .................................................................................................................... 4

4.0 Installation/Mounting ................................................................................................ 5

5.0 Connection ................................................................................................................ 6

5.1 Typical connections

6.0 Operation ................................................................................................................... 9

6.1 Aligning the unit and switching it on

6.2 Switching between sockets 1 and 2

6.3 Adjusting the ash duration

7.0 Technical Data ........................................................................................................... 10

8.0 Warranty .................................................................................................................... 11

– 12 –

Notes

Summary of content (7 pages)

PAGE 1
Table of Contents Notes – 12 – 1.0 Introduction................................................................................................................ 1.1 Unpacking 1.2 Optional Accessories 02 2.0 Safety Information..................................................................................................... 3 3.0 Controls ..................................................................................................................... 4 4.0 Installation/Mounting...........
PAGE 2
1.0 Introduction 8.0 Warranty The LS-18-LED stroboscope is shipped ready for assembly and use. 1.1 Unpacking Unpack the gauge and inspect it for any shipping damage. Notices of defect must be filed immediately, in writing, at the latest within 10 days on receipt of the goods. Your shipment should include: • LS-18-LED stationary stroboscope. • Operating instructions. • One connector for trigger input and power supply. 1.2 Optional Accessories Available • • • • • Stand/wall mount. AC Adapter.
PAGE 3
7.0 Technical Data 2.0 Safety Information General Parameters Frequency range 0 to 120,000 FPM (flashes per minute) Power supply 24 VDC (+/– 10%) DIN 415245-pin standard plug Universal power supply unit available Power consumption 40 Watt External trigger input 3 to 30 V / max. 5 mA potential-free optocoupler DIN 41524 5-pin standard plug Uout = Uin, max.
PAGE 4
3.0 Controls 6.0 Operation On the rear side of the device you will find the following controls. Use of these controls is explained in the following section: 6.1 Aligning the unit and switching it on. 1. Point the stationary stroboscope at a moving object and switch it on. The red LED inside the rocker switch indicates that it is ready for use. If the LED flashes, the unit is connected to the voltage supply but no trigger signal is present.
PAGE 5
D. Trigger signal from optional, hand-operated stroboscope control unit (e.g. RT Strobe control or RT Strobe eco control), supply voltage from optional AC adapter (Fig. 5). 4.0 Installation/Mounting Mount the strobe in the desired location using the threaded inserts located on the underside of the strobe housing (shown below). There are two (2) M5 metric threaded inserts and one (1) 1/4-20 inch threaded insert. Use appropriated plate and screw to attach to customer-supplied mounting fixture.
PAGE 6
5.1 5.0 Connection The stationary stroboscope has three connection sockets on the reverse of the unit which share some identical functions and therefore offer a high level of flexibility. The possible uses and labelling of these sockets are as follows: Marking: 1 Use: Trigger signal input, connection of voltage supply. Marking: 2 Use: Trigger signal input, connection of voltage supply. Typical connection examples: Please take connection examples from Figures 2 to 5.
PAGE 7
CHECK•LINE BY ELECTROMATIC Stationary Stroboscope Model LS-18-LED CHECK•LINE ® INSTRUMENTS ELECTROMATIC E Q U I P M E N T C O . , I N C . 600 Oakland Ave.