User Manual

– 4 –
3.0 Controls

is explained in the following section:
1. Rocker switch marked POWER:
Use to switch the strobe power ON and OFF.
2. Rotary knob marked SHARP/BRIGHT:
Use to adjust the ash duration brightness/sharpness.
3. Rocker switch marked INPUT
Use to select whether socket 1 or 2 should be used for the trigger signal input.
CAUTION
This rocker switch only alternates between the trigger signals. It is still possible, to

Input #2
Power
Trigger Output
(SLAVE?)
Brightness/Sharpness
Adjustment Knob
Multi-Turn Pot
Input #1
External Trigger
Input
Select Switch
– 9 –
6.0 Operation
6.1 Aligning the unit and switching it on.
 
switch it on. The red LED inside the rocker switch indicates
that it is ready for use. If the LED ashes, the unit is
 
present. If the LED remains constantly lit, the unit is
 
2. As soon as the trigger signal is applied, the unit will start to ash with the trigger
frequency.
 
image will appear.
NOTE!
A stationary image will not only appear with an identical ashing frequency, but also
with multiples and fractions thereof.
6.2 Switching between sockets 1 and 2.
1. Use the rocker switch located between the
two sockets to select which socket will be
used for the trigger signal input.
CAUTION!
Ensure that an input signal is present for the
selected socket.
6.3 Adjusting the flash duration.
1. You can adjust brightness and sharpness according to your
requirements using the rotary knob marked
SHARP/BRIGHT with the symbols
.
2. To reduce the brightness, and increase sharpness, turn the
knob counterclockwise towards 
3. To increase brightness and reduce sharpness, turn the knob
clockwise towards 