TR3 Tripod User Manual ANSI Z359.
Issue 0 TR3 Tripod User Manual INDEX Page 1.0 Introduction to TR3 & 3 Scope of Use 2.0 Assembly 4-6 3.0 Confined Space Recommendations 7-8 4.0 Storage, Issue & Inspection 5.0 Quality, legislation & Exclusions 6.0 Installation, Use, Opening/Clearance 9 10 11 - 12 Requirements & Fall Clearance 7.0 Warning! & Compatibility 13 8.0 Labeling 14 9.0 Record Card 15 WARNING! Working at height is dangerous.
Issue 0 TR3 Tripod User Manual PAGE 3 Section 1.0 Introduction to TR3 & Scope of Use TR3 Tripod The TR3 Tripod has been designed for your safety. The TR3 is supplied as a passive fall arrest device. The device is designed to be used above structures and confined entry areas where other attachment is not possible. The TR3 is totally portable and is therefore a temporary anchorage. In the event of a fall the Tripod will provide a tested anchorage and a secondary anchorage for rescue if required.
Issue 0 TR3 Tripod User Manual Page 4 Section 2.0 Assembly NOTE: The Checkmate TR3 and FABX2R/FABXLR are designed for rescue use only. If the device is to be used as a primary man riding winch Checkmate recommend the use of a secondary rescue device. The device is designed to be used in free running mode and in the event of a fall the user can be rescued via the winching facility. For advice or further information contact Checkmate. Fig. 1 Unpack tripod and stand upright. Fig.
Issue 0 TR3 Tripod User Manual Page 5 Section 2.0 Assembly Fig. 7 Fig. 8 Fig. 9 Fig. 10 Fig. 11 Fig. 12 Fix FABXR-DB or FABXLR-DB with two supplied pins. Pull cable up to tripod head and insert hook through central hole. Insert FABX2R or FABXLR into the bracket as shown seating the cable end in the bracket Slide sprung loaded pulley to right, insert cable in pulley groove, and release pulley. Secure with M12 bolt. The device is now ready for use.
Issue 0 TR3 Tripod User Manual Page 6 Section 2.0 Assembly Fig. 1 Fig. 2 Fig. 3 Slide the bracket (WG-02) which is fixed to the winch onto the tripod leg. Align the holes in the bracket with the holes in the tripod leg and insert a detent pin. Insert the second detent pin. Fig. 4 Fig. 5 Pull cable up to tripod head and insert hook through central hole. Slide sprung loaded pulley to right, insert cable in pulley groove, and release pulley.
Issue 0 TR3 Tripod User Manual Page 7 Section 3.0 Confined Space Recommendation Option 1 Primary Fall Arrest Device with Secondary Backup FABX2R or FABXLR When entering a confined space when a fixed access system is installed the user should use: 1 x Tripod (TR3) 1 x SRLR (FABX2R or FABXLR) 1 x SRLR adaptor bracket (FABXR-DB or FABXLR-DB) The FABX2R/FABXLR should be in free run mode and in the event of a fall the device will automatically lock on and then the winch can be engaged.
Issue 0 TR3 Tripod User Manual Page 8 Section 3.
Issue 0 TR3 Tripod User Manual Page 9 Section 4.0 Storage, Issue & Inspection Storage Storage in a central protected location allows assurance of inspection on issue and return This tripod should be stored in a clean dry place where it can be protected from damage by chemical attack and sharp objects . It should be stored with its instructions and record card at all times. After use return to the store, Never leave the device lying around site.
Issue 0 TR3 Tripod User Manual Page 10 Section 5.0 Quality, Legislation & Exclusions 5.1 Quality 5.3 Exclusions All Checkmate products are manufactured under ISO 9001 and to the highest standards. The scope of use within the certification held allows Checkmate to design, manufacture and test Personal Protection Equipment. Horizontal tensile test machine, abrasion testers and dynamic drop test rig are just part of the full range of test facilities used to ensure ultimate safety of our product range.
Issue 0 TR3 Tripod User Manual Page 11 Section 6.0 Installation & Use Installation As a minimum, when in use the tripod must always be installed with either load lifting equipment i.e hand winch and/or load limiting device i.e. SRLR. The device must not be used where the following hazards may endanger the user or prevent the efficient operation of the system. The area below the device must be free of obstruction which may obstruct the movement of the user.
Issue 0 TR3 Tripod User Manual Page 12 Fall Clearance Section 6.
Issue 0 TR3 Tripod User Manual Page 13 Section 7.0 Warnings! & Compatability Warnings! Read and understand manufacturers instructions before inspection, installation or use of this product. Do Not use if you weigh more than 310lbs (141kg). Only use approved equipment with Tripod. If there are any points in this manual that you are unsure of seek a competent, trained person to advise you before using.
Issue 0 TR3 Tripod User Manual Page 14 Section 8.0 Labeling 60MM 46MM DOM: Serial #: ANSI Z359.18-2017 & A10.32-12 / OSHA 1926 Sub M & 1910 Type A Anchorage connector Only make compa�ble connec�ons 5,000 lb. MBS (min. breaking strength). Min. service temperature: -30� F Inspect prior to each use.
Issue 0 TR3 Tripod User Manual Page 15 Section 9.
UM-131_PSGTR3_IS0 Approved service company: Checkmate Lifting & Safety Ltd, Sheerness, Kent. England. ME12 1PZ, UK Tel: +44 (0)1795 580333 Fax: +44 (0)1795 668280 sales@checkmateuk.com www.checkmateuk.
