User`s guide

©Microcontroller-café & Checkpoint LAB M35160 ERASER/PROGRAMMER User’s Guide
3
Cte
1. Introduction
This manual will guide you through the installation of the M35160 Eraser/Programmer,
referenced hereafter as the M35160 programmer. The M35160 programmer has been designed for
on-board access 8/16 Kbit serial SPI EEPROM with incremental registers M35160;D160D0WQ;
D80D0WQ; M35080-3; M35080-6 with clock rates from 3 Mhz up to 10 Mhz via PC or
autonomous control operation mode.
M35160 Eraser/Programmer features
• RS232 interface to PC or USB port (optional)
• 8 - pin socket for M35160; D160D0WQ; D80D0WQ ;M35080-3; M35080-6 devices
• Three push buttons for stand alone operation
• Numeric LED display and three LED’s for indication operating modes
2. Check list and requirements
Hardware requirements
Host - A 32-bit x86 based with a free Serial ports (Com1-10) or USB ports
(optional) a hard-disk system
Memory - Minimum 16 Mbytes
Display - Color VGA display recommended
Power supply - A 10-15 volt/500 mA linear power supply source
Tool - M35160 Eraser/Programmer board*
Cable - An RS232C “straight-thru” cable or USB “A to B” cable (optional)*
Adapters - four 8-pins PCB adapters or ZIP8-DIP8 adapter (optional)*
Software checklist
OS - MS-Windows (Win 98, Win 2000, Win XP; Win 7)
Software tool - - M35160 control software*
* Package check list
M35160 Eraser/ Programmer kit:
- M35160 Eraser/Programmer board **
- 9-pin “straight-thru” cable **
- 8 pins PCB adapters: 4 pcs. **
- CD (control software , documentation) **
- This manual **
Optional:
- USB – RS232 converter ***
- USB cable “A to B” type ***
- ZIF8 – DIP8 programming adapter ***
**NOTE: See M35160 Eraser/Programmer package check list
***NOTE: See APPENDIX I