User's Manual

SIDEP
Page 7 of 19
SYN Trim:VR1
Synchronization
B-TMP Trim:VR2
Alarm sound time: long time in clockwise direction
B-MOD Trim: VR3
Buzzer frequency: low frequency in clockwise direction
L-TMP Trim:VR4
Alarm light time: long time in clockwise direction
RX GAIN Trim:VR5
Sensitivity: high sensitivity in clockwise direction
VOLUME Trim:VR6
Buzzer volume: low volume in clockwise direction
SW1
Reset system
SW2
Test function
DS1
Work display
DS2
Synchronization display
DS3
Alarm display
Firmware version : AMBER_FW_1.0
1.3 POWER SUPPLY
The basic system incorporates a transceiver Antenna, power supply adapter
(PSA). Both 230VAC 50Hz and 120VAC 60Hz main power can be used.
For 230VAC 50Hz main line, input power should be 150mA, and for 120VAC
60Hz main line, input power should be 250mA.
Make sure your anti theft system is connected to an electrical system
complying with the national regulations in force.
Recommended input power of MONO system is 15 VAC 800mA.
Only 1 antenna can be connected to the PSA provided.
Figure 1.3
Cabling shall always be running on the floor inside embedded ducts or in a
groove under the rugs, under floating flooring, in tiling joints or under a sill
nosing, as required.
Cabling acts as an antenna. Under no circumstances shall the cable be
allowed to run through the ceiling or along antennas.