User's Manual

Quick Start Guide: Counterpoint iD
Page 1 of 7
Installation Requirements
What’s In The Box
1 CPiD Chassis
1 Power Supply Unit (PSU)
Install kit including:
2 #8 hex head screws (5/8 inch long)
2 tie wraps
1 6-Pin connector
Tools Req uired
1 small flathead screwdriver
1 1/4 inch nut driver
Optional
DMS Version 1.8.95 or later (required for setup of advanced features)
Operation/Features
Front
1 Sounder Sounder for alarm annunciation
2 Status LED Informs the User about device status. LED Functions are
defined in the label underneath the top plate.
3 Power LED (Green only) Indicates power
4 Volume Knob Adjusts sounder volume
5 Latch Allows user to remove unit for installing external connections
(e.g., cable for Antenna Pad, key switch or lock/trigger)
6 Rubber Boot Conceals DIP Switches, Reset Button and DMS Connection
port