User's Manual

Quick Start Guide: Counterpoint iD
Page 3 of 7
DIP Switch Functions
3 Alarm and Interlock Connection for Interlock and Alarm
Interlock Description / Pin-out
Interlocks are external
devices that relay
control signals to the
device
1 Interlock Input. Default is shorted to Pin 2 using
wire jumper
2GND
3 Interlock Opto, polarity independent (jumper
must be removed prior to use).
4 Interlock Opto, polarity independent (jumper
must be removed prior to use)
Alarm Description / Pin-out
The alarm output
supports generic
sounder devices and
external LEDs
5+12V
6Alarm -
4 +12V Auxiliary Output
and GPIO
Connection for GPIO and +12V output
GPIO Description / Pin-out
General Purpose
Input Output
1 GPO RLY, 1A max resistive load
2 GPO RLY, 1A max resistive load
3 GPI+, 3.3V through 10k Ohm
4GND
+12V Description / Pin-out
This set of terminal
pins is used to
connect devices that
require 12V
5 +12V, 100mA max
6GND
Selection Switch 1 Selection Switch 2 Switch 3 Selection Switch 4 Switch 5 Switch 6
High Power OFF Mode 5 OFF OFF Min Gain OFF OFF OFF
Low Power ON Mode 6 ON ON Gain 2 OFF OFF ON
Mode 4 OFF ON Gain 3 OFF ON OFF
Verification ON OFF Gain 4 OFF ON ON
Gain 5 ON OFF OFF
Gain 6 ON OFF ON
Gain 7ONONOFF
Max Gain ON ON ON