Installation Manual
Table Of Contents
- Statements
- Guide Conventions
- 1
- Background
- F10 System Hardware
- System Diagrams
- Grouping Multiple Antennas
- 2 x 1 Meter Configuration
- 2
- Antenna Distance from Interfering Elements
- System Performance Considerations
- Determining the Electronics Location
- Environmental Considerations
- Site Survey Conclusion
- 3
- Requirements
- Installation Outline
- F10, 1 Meter and 2 Meter Floor Cuts
- Common Wider Floor Cuts
- Mounting the Electronics Enclosure
- Mounting the Power Supply
- Finishing Installation
- 4
- Antenna Wiring
- Wiring the 2 x 1 Meter System
- Overview
- Wiring Between F10 Systems for Sync
- Wiring peripherals
- 5
- System Setup Using DMS
- Application-Based Detection Modes
- Alarm Severity
- Configuring SAM (Smart Alarm Management)
- Updating the System
- 6
- TR4215 Features
- Basic Tuning Methods Using DMS
- Noise Sources
- Analog View
- Evaluate Jumper Positions
- Configuring the System for Asynchronous Noise
- Resonance Sources
- Data Retrieval
- A
- Power Supply Details
- B
- F10 Parts List
- C
- F10 System – Proximity to Deactivation Units
- F10 System – Proximity to Other Systems
- D
- F10, 2 Meter System
- F10, 1 Meter System
F10 Installation Manual Rev. *60 18 of 71
Caution: Prevent uneven stress on the fragile electronic components inside the assembly by ensuring the
floor trough is smooth and level. Fill in uneven areas or gaps with leveling sand or concrete filler.
F10, 1 Meter and 2 Meter Floor Cuts
Installing the F10 antenna assembly in an existing store requires a trough to be cut in the floor.
If the site is under construction, it is easier to mold the system into the floor (explained above).
These diagrams include details on the size of the trough cuts required for each configuration.
Note: Figures are Not Drawn to Scale
127.6cm [50.25in]
35.5cm
[14in]
F10 Matching
Board Location
Figure 3.1 Top View of F10, 1 Meter Floor Cut
F10 Matching
Board Location
21.8cm [8.6in]
234.5cm [92.33in]
35.5cm
[14in]
Figure 3.2 Top View of F10, 2 Meter Floor Cut
Figure 3.3 Trough for the 2 Meter assembly