Installation Manual
Table Of Contents
- Statements
- Guide Conventions
- 1
- Background
- F10 System Hardware
- System Diagrams
- Grouping Multiple Antennas
- 2 x 1 Meter Configuration
- 2
- Antenna Distance from Interfering Elements
- System Performance Considerations
- Determining the Electronics Location
- Environmental Considerations
- Site Survey Conclusion
- 3
- Requirements
- Installation Outline
- F10, 1 Meter and 2 Meter Floor Cuts
- Common Wider Floor Cuts
- Mounting the Electronics Enclosure
- Mounting the Power Supply
- Finishing Installation
- 4
- Antenna Wiring
- Wiring the 2 x 1 Meter System
- Overview
- Wiring Between F10 Systems for Sync
- Wiring peripherals
- 5
- System Setup Using DMS
- Application-Based Detection Modes
- Alarm Severity
- Configuring SAM (Smart Alarm Management)
- Updating the System
- 6
- TR4215 Features
- Basic Tuning Methods Using DMS
- Noise Sources
- Analog View
- Evaluate Jumper Positions
- Configuring the System for Asynchronous Noise
- Resonance Sources
- Data Retrieval
- A
- Power Supply Details
- B
- F10 Parts List
- C
- F10 System – Proximity to Deactivation Units
- F10 System – Proximity to Other Systems
- D
- F10, 2 Meter System
- F10, 1 Meter System
F10 Installation Manual Rev. *60 25 of 71
CHAPTER
4
WIRING
Overview
This chapter instructs on the wiring of the entire floor system. There is a progression from the
antenna to the electronics enclosure and common peripherals. Chapter 4: Wiring concludes with
the DC power supply connections and system sync (optional) wiring schemes for multi-antenna
configurations (i.e., when two or more electronics enclosures are synced – to operate as a unit).
CAUTION: This system uses TR4215
†
DMS version 1.8.31 or later must be used to configure the system after wiring is complete (refer
to
electronics with firmware version 4.00 or higher. It is critical to note
that only TR4215 electronics can be used in conjunction with this system.
Chapter 5: F10 System Configuration via DMS).
The outline below is a sequence of the F10, 1 and 2 meter system wiring procedures:
1. Antenna Wiring
a. Components and Placement
b. Wiring the F10, 1 and 2 meter Antennas to the Impedance Matching Board
2. Electronics Chassis
a. Coax cable Wiring to the Coax Adapter Board
b. Remote Voice Alarm Group Wiring
c. Alarm Post Wiring
d. DC Power Supply Wiring
e. Sync Cable and Power Wiring