Installation Manual
Table Of Contents
- Statements
- Guide Conventions
- 1
- Background
- F10 System Hardware
- System Diagrams
- Grouping Multiple Antennas
- 2 x 1 Meter Configuration
- 2
- Antenna Distance from Interfering Elements
- System Performance Considerations
- Determining the Electronics Location
- Environmental Considerations
- Site Survey Conclusion
- 3
- Requirements
- Installation Outline
- F10, 1 Meter and 2 Meter Floor Cuts
- Common Wider Floor Cuts
- Mounting the Electronics Enclosure
- Mounting the Power Supply
- Finishing Installation
- 4
- Antenna Wiring
- Wiring the 2 x 1 Meter System
- Overview
- Wiring Between F10 Systems for Sync
- Wiring peripherals
- 5
- System Setup Using DMS
- Application-Based Detection Modes
- Alarm Severity
- Configuring SAM (Smart Alarm Management)
- Updating the System
- 6
- TR4215 Features
- Basic Tuning Methods Using DMS
- Noise Sources
- Analog View
- Evaluate Jumper Positions
- Configuring the System for Asynchronous Noise
- Resonance Sources
- Data Retrieval
- A
- Power Supply Details
- B
- F10 Parts List
- C
- F10 System – Proximity to Deactivation Units
- F10 System – Proximity to Other Systems
- D
- F10, 2 Meter System
- F10, 1 Meter System
F10 Installation Manual Rev. *60 32 of 71
Adjusting Jumper Settings
The default jumper settings for the F10, 2 meter system are OUT for J5 - J10.
The settings are adjusted for the F10, 1 meter system. Insert the red J5 and J6 jumpers.
Note: Later on, after the system is initially configured, each of the jumper positions are tested in order to
optimize the tuning of the F10 antenna. Refer to
Evaluate Jumper Positions and complete the test.
Wiring the 2 x 1 Meter System
For the 2 x 1 meter configuration, the wiring to each antenna is consistent with the F10, 1 meter
procedure. The main difference is there are two (2) coax cables routed to the electronics enclosure.
Route each coax cable separately through two different pieces of ENT Tubing. The lengths of
coax cable are connected to the two (2) male connectors on the A1116 Coax Adapter Board.
Note: In instances where multiple electronics and coax cables are used, ensure that floor trenches or
conduits are spaced 5cm [approx. 2in] apart.