Installation Manual
Table Of Contents
- Statements
- Guide Conventions
- 1
- Background
- F10 System Hardware
- System Diagrams
- Grouping Multiple Antennas
- 2 x 1 Meter Configuration
- 2
- Antenna Distance from Interfering Elements
- System Performance Considerations
- Determining the Electronics Location
- Environmental Considerations
- Site Survey Conclusion
- 3
- Requirements
- Installation Outline
- F10, 1 Meter and 2 Meter Floor Cuts
- Common Wider Floor Cuts
- Mounting the Electronics Enclosure
- Mounting the Power Supply
- Finishing Installation
- 4
- Antenna Wiring
- Wiring the 2 x 1 Meter System
- Overview
- Wiring Between F10 Systems for Sync
- Wiring peripherals
- 5
- System Setup Using DMS
- Application-Based Detection Modes
- Alarm Severity
- Configuring SAM (Smart Alarm Management)
- Updating the System
- 6
- TR4215 Features
- Basic Tuning Methods Using DMS
- Noise Sources
- Analog View
- Evaluate Jumper Positions
- Configuring the System for Asynchronous Noise
- Resonance Sources
- Data Retrieval
- A
- Power Supply Details
- B
- F10 Parts List
- C
- F10 System – Proximity to Deactivation Units
- F10 System – Proximity to Other Systems
- D
- F10, 2 Meter System
- F10, 1 Meter System
F10 Installation Manual Rev. *60 33 of 71
Overview
Electronic interfaces / connections to the TR4215 reader board are shown below. This section
describes how to wire all cables and make the appropriate connections at the Electronics Enclosure.
Figure 4.1 TR4215 Board with all interfaces labeled
Coax Cable / A1116 Wiring
The A1116 Coax Adapter Board connects to the F10 antenna via 15m [50ft] coax cable(s).
1. Connect the coax cable to the A1116 adapter board, then clip the Ferrite core (CKP P/N
7784420) over the cable(s).
Note: Ensure that the two (2) output jumpers
are in the Remote Position. J37 and J38
on the TR4215 board are located just
above the A1116 Adapter Board.