Installation Manual

F10 Installation Manual Rev. *60 36 of 71
24VDC Power Supply Wiring
Below are instructions for wiring the 24VDC power supply to the TR4215 board’s DC Input Filter.
1. Cut the MC Armored cable (or generic AWG18 plenum-rated power cable) to length.
2. Strip the 2 (two) leads exposing about 0.6 cm [0.25 in] of the conductors.
3. Apply a Ferrite Core (CKP P/N 7284760) on the power wire near the DC Filter board;
complete 3 loops.
4. Apply the Ferrite Core (CKP P/N 7284760) to the AC power cord.
Figure 14.4 AC Power Cord Ferrite
5. Connect the leads to the DC inputs as shown (or refer to Table 5.5 below).
Figure 4.5 Power Supply connections
(for a Single-Antenna System)
Figure 4.6 DC Power Filter
_______ (Parallel outputs on left and right)
Wire Color
Description
Black
GND
Red
+24 V
Table 4.5: Power Cable Wiring
Connections