Installation Manual
Table Of Contents
- Statements
- Guide Conventions
- 1
- Background
- F10 System Hardware
- System Diagrams
- Grouping Multiple Antennas
- 2 x 1 Meter Configuration
- 2
- Antenna Distance from Interfering Elements
- System Performance Considerations
- Determining the Electronics Location
- Environmental Considerations
- Site Survey Conclusion
- 3
- Requirements
- Installation Outline
- F10, 1 Meter and 2 Meter Floor Cuts
- Common Wider Floor Cuts
- Mounting the Electronics Enclosure
- Mounting the Power Supply
- Finishing Installation
- 4
- Antenna Wiring
- Wiring the 2 x 1 Meter System
- Overview
- Wiring Between F10 Systems for Sync
- Wiring peripherals
- 5
- System Setup Using DMS
- Application-Based Detection Modes
- Alarm Severity
- Configuring SAM (Smart Alarm Management)
- Updating the System
- 6
- TR4215 Features
- Basic Tuning Methods Using DMS
- Noise Sources
- Analog View
- Evaluate Jumper Positions
- Configuring the System for Asynchronous Noise
- Resonance Sources
- Data Retrieval
- A
- Power Supply Details
- B
- F10 Parts List
- C
- F10 System – Proximity to Deactivation Units
- F10 System – Proximity to Other Systems
- D
- F10, 2 Meter System
- F10, 1 Meter System
F10 Installation Manual Rev. *60 38 of 71
Sync Input/Output Connections
Wire Color Description TR4215 Connections
White
SYNC -
J20/J22-1
Green
SYNC +
J20/J22-2
Black & Drain
GND
J20/J22-3
Table 4.6 Sync Input/Output Wiring Connections
2. Prepare the short length of power cable and connect via Daisy Chain to the second electronics
enclosure’s DC +24V Input. Use MC Armored or generic AWG18 plenum-rated power cable.
Wiring peripherals
Use the appropriate installation manual for wiring to the peripheral devices.
For wiring and configuring the Wireless Voice Alarm, refer to the Installation Instructions:
EAS Audible Alarm/Alarm Counter (CKP P/N 7186802)
For hardwiring the EAS Voice Alarm/Counter peripheral, refer to Section 3.1, “Wiring the liberty
PX,” of the Installation Instructions (CKP P/N 7226881).