Installation Manual
Table Of Contents
- Statements
- Guide Conventions
- 1
- Background
- F10 System Hardware
- System Diagrams
- Grouping Multiple Antennas
- 2 x 1 Meter Configuration
- 2
- Antenna Distance from Interfering Elements
- System Performance Considerations
- Determining the Electronics Location
- Environmental Considerations
- Site Survey Conclusion
- 3
- Requirements
- Installation Outline
- F10, 1 Meter and 2 Meter Floor Cuts
- Common Wider Floor Cuts
- Mounting the Electronics Enclosure
- Mounting the Power Supply
- Finishing Installation
- 4
- Antenna Wiring
- Wiring the 2 x 1 Meter System
- Overview
- Wiring Between F10 Systems for Sync
- Wiring peripherals
- 5
- System Setup Using DMS
- Application-Based Detection Modes
- Alarm Severity
- Configuring SAM (Smart Alarm Management)
- Updating the System
- 6
- TR4215 Features
- Basic Tuning Methods Using DMS
- Noise Sources
- Analog View
- Evaluate Jumper Positions
- Configuring the System for Asynchronous Noise
- Resonance Sources
- Data Retrieval
- A
- Power Supply Details
- B
- F10 Parts List
- C
- F10 System – Proximity to Deactivation Units
- F10 System – Proximity to Other Systems
- D
- F10, 2 Meter System
- F10, 1 Meter System
F10 Installation Manual Rev. *60 51 of 71
Figure 5.14 Alarm Patterns Enabled
8. At the bottom of the Patterns tab are the Update and Add buttons used to configure Patterns.
If Add is chosen, the new alarm pattern appears in the list of existing alarm pattern (Light and
Sounder) as shown in Figure 5.15 below.
Figure 5.15 Previously Established Alarm Patterns
9. To Add, select the desired settings from the pattern settings created (refer to Step 15). After
the alarm pattern settings are entered according to the customer’s specifications, add this
specific alarm pattern as a new alarm by clicking Add.
10. To Update, click and highlight the existing alarm pattern (that needs to be overwritten), then
select the desired settings and click Update.
Note: If Update is chosen, this overwrites the existing alarm pattern to the new parameters.