User Manual

Classic IP Style SSB Installation Manual Rev.*60 13 of 27
C H A P T E R
4
ANT ENNA WI R I NG
Overview
This chapter describes the Classic IP Style SSB antennas wiring and cabling.
W ARNING : This system runs on TR4210
†
electronics with firmware version 3.61 or higher. It is
critical to note that ONLY TR4210 electronics can be used in conjunction with this system. It is
also critical that DMS version 1.8.31 or later be used to configure the system.
Information is covered in the following sections:
1. General wiring instruction
2. Aisle wiring
General Wiring Instruction
This section describes how to prepare and wire all cables and wires involved in the antenna
installation. Wires can be cut to required length. Below is a picture of a TR4210 board with all
interfaces labeled.