User Manual

Classic IP Style SSB Installation Manual Rev.*60 18 of 27
Note: It is recommended to leave the pre-terminated coax cable end at SSB location where the
cable was laid out.
Step 3: Connect the SSB Lights/Sounder cable to 6 pin connector as Figure11 shown, colorful
line show the cable that need on site assemble by field servers engineering team .
Step 4: Inspect wiring and connections, confirm coupler board jumper settings (see Figure 10
SSB Coupler Board Jumper Settings).
Step 5: Put the base cover back and secure.
Figure 10 SSB Coupler Board Jumper Settings