Installation Guide Part 2

NGL FX Installation Manual Rev. * 38 of 84
• Connect one drain wire from the 15.2m (50-ft) transmission line to the center terminal
• Connect the ORANGE/WHITE lead to the terminal left of this drain wire
• Connect the WHITE/ORANGE lead to the terminal right of this drain wire
At Connector Port J2 (TX1):
• Connect the second drain wire from the 15.2m (50-ft) transmission line to the center terminal
• Connect the BLUE/WHITE lead to the terminal left of this drain wire
• Connect the WHITE/BLUE lead to the terminal right of this drain wire
.
When the length is less than 15.2m ± .3 m (50’ ± 1”), you should wrap up the cable so that it looks
like a dog bone, with small loops at either end, loosely secured by tie wraps. Place the wrapped
cable next to the electronics enclosure. Do not coil the cable as it will appear as a large tag to the
antennas.
Figure 10: Wrapped Cable