User's Manual
8-6 ILS 2.6 User Guide
Program Continuously so that you do not inadvertently program a circulation circuit
with another item identifier.
• Print Labels: Select if you are printing a label for each circulation circuit you
program.
5 Scan the barcode. The barcode number appears:
Figure 8.7
Barcode Programming
6
Wave the circulation circuit over the CCP. The circulation circuit is read more
quickly if you use and up and down motion over the CCP, instead of waving across the
unit.
7 Your circulation circuit is now programmed and ready to be placed in the material. See
“Affixing Circulation Circuits” on page 9-1 for further instructions.
8 Repeat step 5 through step 7 as necessary to program the rest of your materials.
Removing the CCP Software
1 Click Start > Settings > Control Panel.
2 Double-click Add or Remove Programs.
3 Select Circulation Circuit Programmer and click Remove.
4 Click Next to remove the program.
5 Click Finish to complete the uninstallation.