User's Manual

Circulation Circuit Programmer: Troubleshooting 8-7
Troubleshooting
Label Printing Error
An error occurs when printing. If the fault light flashes and your printer does not have a
built-in cutter, you need to deselect the cutter option in the label properties.
1 If the program is not activated, launch LabelView by clicking Start > All Programs >
CheckPoint XLT+ 7.04 > CheckPoint XLT+ 7.04 to start the program.
2 Press Ctrl + L to access Label Setup.
3 Select the Options tab.
4 Select Don't Cut from the Cut dialog.
5 Click OK to save your changes and try printing again.
Fault appears when printing
Your configured label stores the type of printer. It is possible that the wrong printer is
configured for the label. You can check this by:
1 If the program is not activated, launch LabelView by clicking Start > All Programs >
CheckPoint XLT+ 7.03 > CheckPoint XLT+ 7.03 to start the program.
2 Open the desired label, using File > Open.
3 Click Options > Configurations. The Configuration window appears.
4 Select the Printing Options tab and verify that the printer listed is the printer desired.
5 If not, close this window.
6 Click File > Select Printer and then select Checkpoint MN-4203.
7 Select OK to save your changes and close the window.
Resetting the Printer
1 To reset the printer, turn off the printer.
2 Press and hold the F1, F2, and F3 buttons on the printer while turning on the printer.
3 Continue to hold the buttons down until the PAUSED light turns off. The printer will
now be set to the 'Factory Defaults'.
LabelView does not find *.inf file
If the LabelView software does not find the *.inf file, follow these procedures:
Pre-requisites:
Version 7.03 - Meto Printer software, or,
Version 7.04 - Meto Printer software - this version might cause problems with Windows
XP SP2, if so, use Version 7.03.
1 Insert the Checkpoint Meto Printer CD into the CD-ROM drive of the computer
attached to the Meto printer. Disregard the autostart window of the CD-ROM.
2 Launch the Windows "Add Printers" wizard by selecting Start > Printers and Faxes.